How To Use Api General Cure For New Fish in the USA
For each 10 gallons of water, empty one packet directly into aquarium. Repeat dose after 48 hours. Wait another 48 hours then change 25% of the aquarium water and add fresh activated carbon or replace filter cartridge.
How do you condition a new fish?
Adding the Fish Take the sealed bag that your fish came in and float it on the surface of your aquarium’s water. Allow the bag to sit for ten minutes, then open the bag and add a cup of your aquarium’s water to it. Reseal the bag and let it float again for ten minutes. Repeat the previous step until the bag is full.
When is API General Cure used?
Use 2 packets every 48 hours when symptoms of fungal diseases appear. Directions: Directions: For best results, remove activated carbon or filter cartridge from filter and continue aeration. For each 10 gallons (38 L) of water, empty one packet directly into aquarium.
What is praziquantel for fish?
Praziquantel (Droncit® Mobay Corn.) is commonly used in veterinary medicine to kill cestodes in mammals and digenetic and monogenetic trematodes in fish. Oral doses are reported for praziquantel to treat cestode infections and doses used in bath form exist for treatment of trematodes in fish.
Does API General Cure treat ICH?
Does this treatment be used to treat ick? API General Cure Parasitic Fish Disease Treatment eliminates a wide variety of parasitic diseases including velvet, fish lice, hole-in-the-head, gill worms and dactylogyrus. You would need API Super Ick Cure for Aquariums.
How long does it take for new fish to settle?
Your Aquarium: The First 5 Days After Setup: Let your aquarium “settle” for at least 48 hours before buying your first fish. This will give you time to make sure the temperature is set and make adjustments to decorations, etc.
How do I transition my fish to a new tank?
Acclimatisation Float the bag in your aquarium for 15 to 20 minutes in order for the water in the bag to reach the same temperature as that of the tank. Open the bag and add a cup of water from your aquarium. Reseal the bag. After 30 minutes your fish will finally be ready for the big move.
Will general cure help fin rot?
Be sure there is no chlorine, ammonia, or nitrite in the water and the nitrate is under 40 ppm (mg/L). Once the root cause is corrected, antibiotics will usually cure the disease itself. Treatment with a drug that is effective against gram-negative organisms is recommended.
Can fish recover from hole in head?
Hole in the head can be reversed by removing all activated carbon and conducting large percentage water changes. Greater than 90% water changes may need to be done to reduce the effects of activated carbon. More commonly, cures are made by moving the fish to a new aquarium that has never had fish develop HLLE in it.
How do I use general cure API?
For each 10 gallons of water, empty one packet directly into aquarium. Repeat dose after 48 hours. Wait another 48 hours then change 25% of the aquarium water and add fresh activated carbon or replace filter cartridge.
What are the active ingredients in API General Cure?
Active Ingredients: 500 mg Metronidazole and 150 mg Praziquantel per teaspoon. Active Ingredients: 500 mg Metronidazole and 150 mg Praziquantel per teaspoon. Directions for Use: For best results, remove activated carbon or filter cartridge from filter and continue aeration.
How do you use a multi cure fish?
Dosage rates: Use 0.25ml (5 drops) per 1L of use at the rate of 5mL per 20L of aquarium water. For tetra species, baby fish and scaleless fish (loaches etc) use at a rate of 5mL per 40L of aquarium water. DO NOT OVERDOSE. Repeat treatment after 3 days.
How do you mix praziquantel?
is soluble in alcohol and only slightly soluble in water, so the required dose of praziquantel was dissolved in a small volume of 70% isopropyl alcohol at a rate of 1 mg/16.7 mL of isopropyl alcohol before adding it to the treatment water (Table 1).
When do you use praziquantel for fish?
In the aquarium industry, PZQ can be administered in a “bath” to treat the presence of ectoparasites on both the gills and skin of fish and elasmobranchs. In order to fully treat an infestation, the bath treatment has to maintain therapeutic levels of PZQ over a period of days or weeks.
How do you give praziquantel to fish?
Application of Praziquantel: Remove any carbon / charcoal from your pond or filter. Turn off your ultraviolet clarifier. There is no need to bypass your biological filter. Apply the appropriate amount of prazi to your pond. If needed, reapply after 4 to 5 days.
Is API General Cure safe for reef tank?
Louisiana Reef Club Assuming powder praziquantel can be dissolved in a large body of water (at least 10 gallons), then yes. General Cure also contains metronidazole, which is easily water soluble and treats internal/intestinal parasites.
Can humans get parasites from fish tank?
People can become infected with Mycobacterium marinum by having direct contact with infected animals or contaminated water (for example, contaminated ponds or aquariums). The most common sign of infection is development of a skin infection. In very rare cases, the bacteria can spread throughout the body systems.
Is ICH bacterial or fungal?
Ich is caused by an external parasite that causes multiple white spots on your freshwater fishes’ skin and gills. This is a common parasitic infection of freshwater fish and is one of the few fish parasites that can be seen with the naked eye.
Should you feed fish after acclimation?
There is no rule to feeding new fish straight after acclimation, but the fish will tell you. Some fish will be out swimming immediately, while others may go and hide. A small feed to test their appetite will show if they are ready to accept food.
Can you put cold water fish straight into a new tank?
If your aquarium water is ready, we would advise stocking the tank very slowly to avoid filter overload – one or two fish to start with, then if there is no deterioration in water quality after 2 weeks, then you can add another one or two fish.
How long should you wait before putting cold water fish in a new tank?
Wait until both the ammonia and nitrite levels have risen and then fallen to zero before adding more fish. It usually take about 3-6 weeks for a new aquarium to go through the initial nitrogen cycle, so fish should be added only a few per week during this time.